ElectricalSolutions Products

Secondary injection testing

Tue, 23 Jun 2009 05:23:11 +0000

Lightweight and compact, the CMC256 claims to be the most powerful solution in the field of secondary injection testing. The CMC 256-6 is available with the EP (Extended Precision) hardware option.

Condensation solution system

Tue, 23 Jun 2009 05:24:51 +0000

Hoffman announces the H2OMIT Thermoelectric Dehumidifier and UL 4X Listed Vent Drain, designed to protect sensitive electrical and electronic equipment from damage caused by condensation.

Earth ground tester kit

Tue, 26 May 2009 02:28:57 +0000

The Fluke 1625/1623 earth ground testers can perform all four types of earth ground measurement.

Industrial ethernet switches

Tue, 03 Feb 2009 04:24:32 +0000

The Rockwell Automation/Cisco co-branded Stratix series is a range of industrial ethernet switches.

Cable certification and ethernet tester software

Tue, 03 Feb 2009 04:20:18 +0000

An advanced network test option for the WireScope Pro cable certification tester has been released for the validation and pre-qualification of voice over IP services and to stress test ethernet connections.

Output filters for motor drives

Thu, 05 Feb 2009 04:42:17 +0000

The Schaffner 510 series output filters reduce voltage slew rate (dV/dt) from inverter drives for variable-speed motors. High-voltage slew rates can cause overstressing of long motor drive cables and cause insulation breakdowns in motor windings.

Analyser for renewable energy systems

Tue, 03 Feb 2009 04:22:52 +0000

The WT500 power analyser addresses renewable energy systems with the capability of simultaneously measuring DC and AC signals and calculating system efficiency. Separate integrate functions are also included to enable evaluation of charge/discharge and bought/sold power in photovoltaic systems.

Benchtop drop saw

Tue, 03 Feb 2009 04:19:47 +0000

The Willy 225 industrial strength sawing machine is a small bench-model sawing machine that is built entirely from cast iron and features bronze gear, case-hardened grounded worm screw and screw-locked swivelling head for mitre cuts of 0 to 45° left.

Power analyser

Tue, 03 Feb 2009 05:04:02 +0000

The Voltech PM 1000+ precision power analyser is suitable for single-phase power and energy measurement of power circuits, industrial and domestic appliances, linear and switchmode power supplies and can also be used to measure inrush parameters under zero-crossing or peak values (using Voltech PS 1000 Inrush Switch).

Clamp-on AC logger

Tue, 03 Feb 2009 05:03:13 +0000

The Simple Logger II Model CL601 is a battery-powered, 1-channel recording device with an alkaline battery pack. Line tracking is performed such that 64 samples over one line cycle are taken. Harmonic measurements are calculated from these 64 samples. Frequency tracking is performed over the range of ±2 Hz around the nominal line frequency (50 or 60 Hz).

Surge protection

Tue, 03 Feb 2009 04:18:29 +0000

The SLT range of threaded instrument protectors provides surge protection for most forms of industrial monitoring and control.

Video surveillance data enclosure

Thu, 05 Feb 2009 04:43:31 +0000

The Rittal security box enclosure is a tamper-proof security enclosure aimed at helping organisations protect their video surveillance equipment from unauthorised access.

Harmonic filtering solutions for VSDs

Tue, 03 Feb 2009 05:05:05 +0000

NHP’s Advanced Active Front End/Regenerative VSD solutions produce a very low level of harmonic distortion in addition to providing benefits for managing regenerative energy back into the mains power grid.

Noise suppression chokes

Tue, 03 Feb 2009 04:27:05 +0000

Schaffner noise suppression chokes cover symmetrical (differential) and asymmetrical (common-mode) noise suppression.

Intrinsically safe transceiver

Tue, 03 Feb 2009 05:08:31 +0000

The Banner Engineering DX99 wireless transceiver node is designed for installation in hazardous areas and combines three technologies in a single housing: battery-based power supply, wireless technology for mission critical data and intrinsically safe operation.

Industrial category 6 UTP cables

Tue, 03 Feb 2009 04:17:18 +0000

The DataTuff 7940A category 6 unshielded twisted pair cable is designed for industrial ethernet applications such as mission-critical network and automation system backbones being installed in discrete industrial manufacturing, processing plants and large industrial infrastructures such as water treatment and utility plants, airports, transportation terminals and shipyards.