Flourish restoration

Sole Boards and final fit out.

2012-06-02T22:45:00.000-07:00

My youngest daughter helping me with the very tedious task of fairing the boat. I think she lastest about 10 minutes.

Fitting Out.

2012-02-28T04:15:00.001-08:00

I've had a few visits from some little friends recently.

Patterning out the hanging knees which fit above the top plank and under the inwale.
Once varnished they're be glued and screwed through the planking aswell.

Making a pattern for the rear bench seat using 3mm pattern-ply and a glue gun.

Gluing-up the blank using re-cycled Sapele.

Fliss and her cousin Freya choosing their seating positions.

Bench seat fitted prior to lateral supports which will sit across the stringers.

Breasthook and knees.

2012-02-22T12:57:00.000-08:00

The Breasthook is a piece of timber that fits into the bow of the boat between the inwales for structural completion. Ideally it is cut out of a grown 'crook' of timber, the grain direction following the the curvature so there is no short grain to fracture. This is a limb of English Oak just right for the job. If you look closely you can see the template marked out prior to fitting.

Dry fitting the knees allowing for the curvature of the transom. They are half lapped as per the original knees and will be fastened with copper nails to secure the overlap as grown knees are difficult to come by...

Steaming Inwales

2012-02-16T12:50:00.000-08:00

For the rubbing strake (top plank) and the inwales I decided to use Pitch Pine for its durability and aesthetic, although the the originals I believe were Siberian Larch.

Rather than risk splitting the timber (a fairly hefty 25mm by 35mm section) I pre-stressed it before steam-bending around the top plank as a former. I constructed a fairly crude steam box out of old dust extraction bags stapled together and hooked up the trusty wall paper stripper. Hey presto!

The clamps were left on for a couple of days, then the inwales were trimmed fore and aft, glued and fastened with silicon bronze screws.

Pre-stressing the inwales prior to steaming.

Oars

2012-02-15T09:54:00.000-08:00

Unfortunately I didn't take any photos when I constructed these Oars. They were a pleasure to design and make, but I didn't realise the effort, design and time that goes into them.

I received a lot of guidance from Julian Burns (now retired from Sail and Oar) who kindly explained the principles and construction of Oar making.

They are are built using English Ash; the Looms are laminated in two sections and glued using epoxy resin. The blades are then added before shaping. The length is determined by a number of factors; the beam of the boat, the freeboard (distance from the waterline to the top of the rubbing strake, plus the height to the rowlock) and more...

The transition of the loom to the blades is an elliptical section where strength is only needed in one plane thereby minimising weight. Inboard from the rowlocks the loom is left in the square to counterbalance the weight outboard.

This determined a length of 9'3" for the central rowing position and in time I will make some slightly shorter oars for the forward position as she was was designed as a two man skiff.

Flourish as she was October 2009. Tom my brother in-law squatting in the background.

2012-02-04T07:50:00.000-08:00

Last frame in! With the assistance of my friend Iain. Wednesday 1st February 2012

2012-02-04T07:40:00.000-08:00