Brand new McLaren given a thorough decontamination to remove all contaminants that have bonded on the paint during transport.

A perfectly clean surface to ensure perfect film adhesion.

Front end wrapped in Xpel Ultimate Film.

The plastic lenses on headlights these days get chipped so easily, thus getting edge to edge protection with Xpel PPF.

Removed the thick and dull film that the dealer had installed on the bottom of the carbon fibre side skirts.

And installed a single piece of self-healing Xpel Ultimate that covers both the top and bottom surface of the side skirt.

Wrapping this expensive carbon fibre piece for full coverage against rock chips.

Doors getting wrapped in PPF.

Full coverage as well as extended edges wherever possible for a seamless install.

Inner part of the air inlet duct getting precut coverage as well to ensure perfect fitment.

Rear quarter of the vehicle getting wrapped.

Pillars wrapped from front to back.

Finished pic of the carbon fibre side skirts wrapped in Xpel Ultimate.

Vehicle complete and ready for delivery.

Upon arrival at the office where the car is currently stored.

The interior was the first order of the day. Not too much had to be done in the cabin as the carpets and seats were in pretty good shape.

Interior after.

Haven’t seen a center console like this in forever!

Making sure to clean up all the dirt on the carpets under the seats.

Leather after being cleaned and conditioned.

Love the color-matched fibers in the floor mats.

Walked around the car to inspect the defects.

Lots of swirls built up over the years from improper washing techniques.

Started machine polishing on the hood to remove the top layer of defects.

Opened up the overhead door to inspect the hood in the sun. Looking much better after majority of the swirls were removed.

More swirls on the front fender.

Swirls and scratches found all over the car.

Front fender before.

Front fender after polishing.

Front bumper before polishing.

Front bumper after polishing.

Light swirls on the front door.

Defects removed and gloss significantly enhanced.

50/50 shot of the door. The closer side has been polished, while the other half shows the original defects.

Another 50/50 shot of the passenger side door. Notice the richness in the red on the polished side.

Quarter panel before.

Quarter panel after.

Taillights were pulled to get better access with my polisher.

Lots of dirt and defects were visible once the taillight housing was removed.

Surrounding area all cleaned up and polished.

Swirls were found even under the license plate.

Rear hatch before.

Rear hatch after correction.

The emblem was very faded and had lots of wax residue built up from previous detailing.

Wax residue removed and emblem was cleaned and reconditioned.

After all the polishing was complete and the paint protected with a sealant, it was time to pull her outdoors for inspection.

Loving her new glossy shell!

Beauty shots.

Thank you for looking!

Pricing as follows (per set):
New wheels: $250
Used wheels: $300
Removal + Re-install: $50

Buildup of brake dust and iron deposits on the face of a used BMW wheel.

After a full cleanse + Ceramic coating.

This wheel went a full year of driving without ever having the barrels cleaned.

After a full cleanse + application of the wheel coating.

Close up of the brake dust buildup.

Brake dust, tar spots, and all iron deposits were properly removed, leaving a perfectly clean finish for proper coating application.

Close up of the lettering on the back of the spokes, none of which were visible before cleansing.

GlossWorks was contacted and it was time for some professional paint correction to take place.

The wagon when it showed up for detailing.

The front end of the car had old adhesive residue left behind from being taped up for a drive from the East Coast.

The vehicle had dirt hiding in all the crevices.

The wheels were in great shape, but the barrels needed to be properly decontaminated.

Buildup of brake dust and iron deposits.

The exhaust tips would require some polishing to revive the shine.

The engine bay was in great condition, with just some light dusting from being daily driven.

The engine bay was first given a shampoo + degreasing.

This beautiful engine being shown some GlossWorks TLC.

Removing a heavy buildup of dirt that has found its way under the gas cap after all these years.

Tires were properly scrubbed to remove the accumulation of dirt and old tire dressing.

After a full cleanse of the paintwork and removal of contaminants, the car was dried and the paintwork inspected.

There was a healthy dose of swirls all over the car.

This was removed with a heavy step of compounding, followed by a gloss enhancing finishing polish.

Continuing my way around the car with the polisher, ensuring that all the delicate trim is taped up to prevent damage.

Some deep scratches and defects under the tape line.

The defects were leveled, leaving behind a perfect finish.

After a day and a half of polishing comes my favourite part of the detail. Tape removal!

The car being rolled out on the 2nd day after being fully polished and sealed.

The wheel faces and barrels are fully cleaned, and tires properly dressed for the perfect sheen.

Gloss and depth of paint significantly improved.

Reflection off the hood.

The paint was sealed with a polymer sealant, enhancing the metallic flakes in the paint.

All brake dust and tar/iron deposits removed, leaving a perfect finish on these gorgeous wheels.

Last shot of this beautiful wagon. Thanks for looking!

XPEL’s Ultimate Paint Protection Film combines best-in-class durability and clarity not previously available in the market. With its very low surface energy, XPEL ULTIMATE sheds contaminants that would otherwise stain or yellow conventional films. In addition, the clear coat employs special elastomeric polymers that “heal” over time eliminating swirl marks and other fine scratches without having to do anything.

This product carries a 10 year warranty against, yellowing, cracking, peeling, staining, and hazing, covering both film and labor. XPEL ULTIMATE is truly the most revolutionary Paint Protection Film ever invented!

Aquapel Glass Treatment is designed to change the way drivers see the road in the rain. It can also be used on any window where clearer vision is needed. Aquapel will also fight the elements for auto, marine and home applications.

First developed and patented by PPG Industries, the leaders in glass technology, and now owned by Pittsburgh Glass Works, Aquapel Glass Treatment represents a product which promotes automobile safety.

Designed for professional application on windshields, side windows, rear windows, glass shower doors, or any other glass surface, Aquapel is a long-lasting glass treatment that:

• Repels rain for remarkably improved vision
• Makes it easier to clear ice, snow and even dirt
• Reduces glare in the rain, especially at night
• Helps reduce water marks and keeps down salt water

Drive Safer

Of course the best way to see how Aquapel Glass Treatment works is to have it applied on your windshield. Ask about the Aquapel Treatment the next time your vehicle’s finish is professionally serviced by GlossWorks.

See Clearly. Drive Safer… today and every day with Aquapel. When your safety is involved, SEE CLEARLY and DRIVE SAFER.

Remember to ask about having the Aquapel treatment during your next detail!

GlossWorks is off travelling the world again! This time I will be visiting the Philippines in July 2012 for an indefinite period of time and will be available on a limited schedule for paint correction services of any prestige performance vehicles. This is an exclusive opportunity for anyone in the Manila area to experience first-hand the services that we offer.

Please contact me at info@glossworks.ca with the model of car and contact information if you are interested.

Heavy swirling visible on the hood.

A couple fine scuffs on the headlights.

Scuffs corrected after machine polishing and sealed for protection.

Light swirling on the tail lights.

Machine polished to improve clarity and shine.

Hood taped off to test a few different polishing combinations.

50/50 shot of the rear fender. Area that has been polished is showing more clarity and gloss.

All plastic surfaces were cleaned and sealed.

Exhaust tips were polished and sealed as well.

Tail lights showing much crisper reflections now that they have been polished.

Wheels were meticulously cleaned and sealed for maximum brake dust protection.

Cleaned, polished, sealed, and fully protected for the winter elements.

Thanks for looking!

(Not redeemable for cash. The Christmas gift certificates are valid till April 30th, 2012.)