Notebook Guide

How To Repair Laptop Batteries

2008-09-30T05:02:00.000-07:00

Repair your laptop batteries...
I hope you can enjoy this tutorial...

How To Repair Laptop Hardisk

2008-09-30T04:41:00.001-07:00

How To Repair Laptop Hardisk - The funniest videos are a click away

How To Repair Hard Drive

2008-09-30T04:34:00.000-07:00

This is a tutorial video to repair laptop hardisk...
Click and learning...

How to Remove your Laptop Screen

2008-09-30T04:33:00.000-07:00

here you can find info about remove your nootbok LCD Screen by your self .
enjoy.

How TO Repair Hard Drive

2008-09-30T04:31:00.000-07:00

First of all you need to find out what is the real problem with your drive. You have to be 100% sure that you diagnosed the hard drive correctly. And serial port (so-called "Terminal") is the only "proper" way to diagnose a Seagate hard drive. Forget about swapping heads until you are absolutely sure they ARE the problem. There is no room for mistake.

There are lots of reasons why a hard drive can make clicking noise, and yes, the most common reason is malfunctioning head stack (either a head itself or the preamplifier chip that is located on the head stack). But there are chances that the problem is not the head stack. You need to find that out via Seagate's serial port.

Again, never open a drive unless you are 100% sure that the problem is inside. This applies to everyone, including all data recovery people out there.

Now, speaking about heads, it is possible to change the head stack without damaging platters. somehow manage to swap 14+ heads head stacks without it being something very special to them. You just need some good experience but it is worth repeating good data recovery people spent years to gain the knowledge and experience needed to perform something that is slightly more than just swapping PCBs and using Winhex.

Anyhow, here's my plan:

1. Pop the cover

2. Make the platters spin to create air cushion

3. Remove the top magnet

4. Put the pieces of paper onto the platters, so that heads will slide down onto them, hopefully preventing the heads from crashing onto each other.

and again please be careful when you doing that with your hard drive you must do that first with damaged hard drive first .

Laptop DVD Tray Won't Eject - How To Open A CD Or DVD Drive

2008-09-19T07:44:00.000-07:00

There are quite a few reasons the DVD tray in your laptop might fail to open when you hit the eject button. About the worst thing it can be is if the motor or gear train failed, which would mean replacing the drive. If the disc in the drive plays OK, you know that the power and the connector are fine. If not, you should try reseating the drive in the bay. It's also possible for the drive to be locked in software by the operating system, or for a power management scheme to have cut power to the drive. Check these by right clicking the drive icon and checking properties, or looking at you power management settings. But, when all else fails and you can't get the disc out of the drive, you may need a paperclip.
Like this :

Good Luck !!!