Not so short introduction to 4G

2012-02-12T17:43:00.000+01:00

3GPP Long Term Evolution, usually referred to as LTE, is a standard for wireless communication of high-speed data for mobile phones and data terminals. It is based on the GSM/EDGE and UMTS/HSPA network technologies, increasing the capacity and speed using new modulation techniques. The standard is developed by the 3GPP (3rd Generation Partnership Project). LTE is the natural upgrade path for carriers with GSM/UMTS networks, but even CDMA holdouts such as Verizon Wireless, who launched the first large-scale LTE network in North America in 2010, and au by KDDI in Japan have announced they will migrate to LTE. LTE is, therefore, anticipated to become the first truly global mobile phone standard.

Although commonly referred to as a type of 4G wireless service, LTE release 8 currently in use does not satisfy the requirements set forth by the ITU-R organization. Future releases of LTE (referred to as LTE Advanced) are expected to satisfy the requirements to be considered 4G.

Many operators have not yet upgraded their basic 3G networks, and 3GPP LTE is seen as the next logical step for many operators, who will leapfrog straight from basic 3G straight to LTE as this will avoid providing several stages of upgrade. The use of LTE will also provide the data capabilities that will be required for many years and until the full launch of the full 4G standards known as LTE Advanced. Although there are major step changes between LTE and its 3G predecessors, it is nevertheless looked upon as an evolution of the UMTS / 3GPP 3G standards. Although it uses a different form of radio interface, using OFDMA / SC-FDMA instead of CDMA, there are many similarities with the earlier forms of 3G architecture and there is scope for much re-use.

LTE can be seen for provide a further evolution of functionality, increased speeds and general improved performance.

In addition to this, LTE is an all IP based network, supporting both IPv4 and IPv6. There is also no basic provision for voice, although this can be carried as VoIP. LTE has introduced a number of new technologies when compared to the previous cellular systems. They enable LTE to be able to operate more efficiently with respect to the use of spectrum, and also to provide the much higher data rates that are being required.

OFDM (Orthogonal Frequency Division Multiplex): OFDM technology has been incorporated into LTE because it enables high data bandwidths to be transmitted efficiently while still providing a high degree of resilience to reflections and interference. The access schemes differ between the uplink and downlink: OFDMA (Orthogonal Frequency Division Multiple Access is used in the downlink; while SC-FDMA(Single Carrier - Frequency Division Multiple Access) is used in the uplink. SC-FDMA is used in view of the fact that its peak to average power ratio is small and the more constant power enables high RF power amplifier efficiency in the mobile handsets - an important factor for battery power equipment.
MIMO (Multiple Input Multiple Output): One of the main problems that previous telecommunications systems has encountered is that of multiple signals arising from the many reflections that are encountered. By using MIMO, these additional signal paths can be used to advantage and are able to be used to increase the throughput. When using MIMO, it is necessary to use multiple antennas to enable the different paths to be distinguished. Accordingly schemes using 2 x 2, 4 x 2, or 4 x 4 antenna matrices can be used. While it is relatively easy to add further antennas to a base station, the same is not true of mobile handsets, where the dimensions of the user equipment limit the number of antennas which should be place at least a half wavelength apart.
SAE (System Architecture Evolution): With the very high data rate and low latency requirements for 3G LTE, it is necessary to evolve the system architecture to enable the improved performance to be achieved. One change is that a number of the functions previously handled by the core network have been transferred out to the periphery. Essentially this provides a much "flatter" form of network architecture. In this way latency times can be reduced and data can be routed more directly to its destination.

One of the key elements of LTE is the use of OFDM (Orthogonal Frequency Division Multiplex) as the signal bearer and the associated access schemes, OFDMA (Orthogonal Frequency Division Multiplex) and SC-FDMA (Single Frequency Division Multiple Access). OFDM is used in a number of other of systems from WLAN, WiMAX to broadcast technologies including DVB and DAB. OFDM has many advantages including its robustness to multipath fading and interference. In addition to this, even though, it may appear to be a particularly complicated form of modulation, it lends itself to digital signal processing techniques. In view of its advantages, the use of ODFM and the associated access technologies, OFDMA and SC-FDMA are natural choices for the new LTE cellular standard.

Borgthor Gretarsson blog

Not so short introduction to 4G